Tuning To Radio Stations - Philips AZ 1060 Handbuch

TUNING TO RADIO STATIONS

1. Select TUNER source.
™ The function indication lights up.
and then the radio station frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH ∞ or § and release when the frequency in
the display starts running.
™ The radio automatically tunes to a station of sufficient
reception. Display shows
™ If a FM station is received in stereo,
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception
– For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
– For MW/AM/LW, the set is provided with a built-in aerial
so the telescopic aerial is not needed. Direct the aerial by
turning the whole set.
5. To switch off, adjust the POWER slider to TAPE/
with the keys on the tape deck released.
™ The function indicator goes out.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
– Display: flashes.
PROGRAM
3. Press PRESET 4 or 3 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
– Display: disappears, the preset number and the
PROGRAM
frequency of the preset station are shown.
5. Repeat the above four steps to store other stations.
– You can erase a preset station by storing another frequency in
its place.
Tuning to preset stations
Press PRESET 4 or 3 until the desired preset station is
displayed.
is displayed briefly
during automatic tuning.
is shown.
STEREO
position
OFF
DIGITAL TUNER
STEREO FM
7