Power Cable - ASROCK 890GX EXTREME4 Bedienungsanleitung

All manuals and user guides at all-guides.com
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA1 (PORT 0): see p.2, No. 20)
(SATA2 (PORT 1): see p.2, No. 19)
(SATA3 (PORT 2): see p.2, No. 21)
(SATA4 (PORT 3): see p.2, No. 17)
(SATA5 (PORT 4): see p.2, No. 18)
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)

Power Cable

(Optional)
connect to the SATA
HDD power connector
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 31)
(9-pin USB8_9)
(see p.2 No. 30)
(9-pin USB10_11)
(see p.2 No. 29)
ASRock 890GX Extreme4
These five Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
connect to the
power cable to the power
power supply
connector of the power supply.
Besides four default USB 2.0
ports on the I/O panel, there are
three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
Motherboard
2 7 2 7 2 7 2 7 2 7