Service Data; Installation; General Information - Electrolux MO325G Benutzerinformation

16 www.electrolux.com
Problem
The lamp does not
operate.
There is sparking in
the cavity.
There is sparking in
the cavity.
The turntable set
makes scratching or
grinding noise.
The appliance stop
to operate without a
clear reason.

11.2 Service data

If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

12. INSTALLATION

WARNING!
Refer to Safety chapters.

12.1 General Information

CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
Possible cause
The lamp is defective.
There are metal dishes or
dishes with metal trim.
There are metal skewers or
aluminium foil that touches the
interior walls.
There is an object or dirt be‐
low the glass cooking tray.
There is a malfunction.
Remedy
The lamp has to be replace.
Remove the dish from the ap‐
pliance.
Make sure that the skewers
and foil does not touch the in‐
terior walls.
Clean the area below the
glass cooking tray.
If this situation repeats call the
Authorised Service Center.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the appliance. Do not remove
the rating plate from the appliance.
........................................
........................................
........................................
CAUTION!
The minimum installation
height is 85 cm.
• The microwave is for built-in use only.
It must be placed on a stable and flat
surface.
• The cabinet can not have a back wall
in the place where the microwave is
located.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is to close to the TV
and radio it may cause interference in
the received signal.
• If you transport the microwave in cold
weather, do not activate it
immediately after the installation. Let