wilux DUOLIGHT Bedienungsanleitung Seite 12

Istruzioni Duolight 05-04-2004 09:11 Pagina 12
All the whirlpool bath components require maintenance. Please follow the instructions
below to avoid damage to the gloss of the acrylic and metal parts:
• Clean the bathtub with a soft cloth and neutral liquid detergents that are not abrasive.
Never use cloths with synthetic fibres, scouring pads, metal pads, abrasive detergents
(liquid or solid), alcohol, and acids for domestic use, acetone or any other solvents,
which may damage the surfaces.
• Do not use bath foam, oil or other detergents, which are not specifically indicated for the
whirlpool systems (not completely soluble and thus potentially abrasive).
• Use diluted lukewarm vinegar to remove any calcium deposits.
• Damages caused by calcium deposits are not covered by warranty. We advise the
installation of a water-softening system to avoid calcium deposits.
• Do not expose the bathtub to excessive ultraviolet rays, such as a solarium near the
bathtub, or direct sunlight to avoid colour changes of the bathtub.
• Minor damage can be eliminated with a reparation kit (available in the colours of the
sanitary units. Small scratches can be removed by passing sandpaper gently (no. 1200)
and then applying car polish.
• Periodically it is advisable to clean the whirlpool water circuit activating the cleaning
cycle (if provided) according to the instructions for each single system.
Installation PLUS-System
The PLUS System needs a separate cold water connection, beyond the ones used to fill
the bathtub.
The solenoid valve for the PLUS System will be attached to the separate cold water
connection.
NORMAL AND SPECIAL MAINTENANCE
Attack PLUS-System
12