Ribimex Ribiland PRBAT20/TH Bedienungs- Und Wartungsanleitung Seite 29

I –
MPORTANT
DURING OPERATION
T , NOT .
O PROLONG THE LIFE OF YOUR ENGINE DO USE BY PRESSING THE SWITCH WITH JOLTS
S .
TART AND STOP THE ENGINE BY PRESSING AND RELEASING THE SWITCH GRADUALLY
ATTENTION! Do not assume of your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting
strict compliance to the safety instructions given with the tool.
Improper use of the tool or failure to comply with the provided safety instructions in this manual can
cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Remain alert about your surroundings and especially for any danger that you may not hear while
using the tool.
5.3- Tips
- The trimming cut will be improved if an angle of 5°, between the hedge and the blade, is kept
during the operation. (Fig.A)
- Both sides of the cutting blades allow to trim both ways: from right to left or left to right (Fig.B).
- To achieve a regular trim, we recommend you limit the side of the hedge with a wire or line. Only
the branches higher than the top of the wire or line should be cut (Fig.C).
- The sides of a hedge should be trimmed from bottom to top (Fig.D).
Fig.B Fig.D
Fig.C
Fig.A
Important :
- Large branches should be cut with shears.
- In case the blades get blocked, stop the hedge trimmer and remove the battery. Then, proceed to
clear the blockage.
Page 29 / 81