Water Drainage - ZIBRO CLIMA D901 Gebrauchsanweisung

3
4
5
ATTENTION
C

WATER DRAINAGE

The red light » will switch on when the reservoir is full. A safety system ensures
A A
that the machine then switches itself off. Simply remove the reservoir to drain the
water (fig. A).
EXTERNAL DRAINAGE
If desired, it is possible to fit a drainage hose to the machine. Follow the steps
below:
1
B B
2
3
4
28
901 / 1001
Turn the control button · to:
'Normal' setting
for automatic operation based on a normal humidity level (between 45%
and 60%). The machine will switch off automatically when a humidity level
of 50% is reached, and switch on again when the humidity level increases.
'Max' setting
for continuous operation in specific situations, such as drying clothes, etc.
Select the ventilator speed:
Silent Mode
The dehumidifier operates on reduced power at this setting (180 m
Standard Mode
The dehumidifier can be set for normal operation by pressing the selector
button (300 m 3 /h).
Turn the control button · to:
'0' setting
to switch the machine off.
Adjusting the ventilator speed reduces the noise level. However, this also
causes a slight loss of capacity as the machine works with reduced power at
this setting.
We recommend that the machine be set to operate on reduced power if the
humidity level is lower than 60% in order to generate the optimum power
consumption/benefit ratio.
Remove the reservoir from the machine.
Remove the plug from the end of the drainage spout.
Connect the drainage hose to the spout (fig. B). The drainage hose is available
at your dealer's.
3 /h).