Water Drainage - ZIBRO CLIMA D12 Gebrauchsanweisung

3
4
5
ATTENTION
A A
C

WATER DRAINAGE

The red light » will switch on when the reservoir is full. A safety system ensures
that the machine then switches itself off. Simply remove the reservoir to drain the
water (fig. A).
EXTERNAL DRAINAGE
If desired, it is possible to fit a drainage hose to the machine. Follow the steps
below:
B B
1
2
3
4
5
4
28
Turn the control button · to:
'Normal' setting
For automatic operation based on a normal humidity level (between 60%
and 70%). The machine will switch off automatically when a humidity level
of ± 60% is reached, and switch on again when the humidity level
increases.
'Min' setting
for continuous operation in specific situations, such as drying clothes, etc.
Select the ventilator speed:
Silent Mode
The dehumidifier operates on reduced power at this setting.
Standard Mode
The dehumidifier can be set for normal operation by pressing the selector
button.
To switch the machine off:
Press the -button
Adjusting the ventilator speed reduces the noise level. However, this also
causes a slight loss of capacity as the machine works with reduced power at
this setting.
We recommend that the machine be set to operate on reduced power if the
humidity level is lower than 60% in order to generate the optimum power
consumption/benefit ratio.
Remove the reservoir from the machine.
Remove the plug from the end of the drainage spout.
Connect the drainage hose to the spout (fig. B). The drainage hose is available
at your dealer's.
The hose is led away through the hole in the bottom of the machine.
Re-install the reservoir into the machine.