Sony IPELA PCS-XG80 Bedienungsanleitung Seite 16

Owner's Record
The model and the serial numbers are
located at the bottom. Record the serial
number in the space provided below. Refer
to these numbers whenever you call upon
your Sony dealer regarding this product.
Model No. ______________
Serial No. ______________
WARNING
To reduce a risk of fire or electric
shock, do not expose this product
to rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing to
qualified personnel only.
IMPORTANT
The nameplate is located on the bottom.
Notice
The PCS-XG80S and the PCS-XG80 are
systems each of which contains Model No.
PCS-XG80S as a main unit. Always refer to
Model No. PCS-XG80S for regulatory
compliance purpose.
The PCS-XG55S and the PCS-XG55 are
systems each of which contains Model No.
PCS-XG55S as a main unit. Always refer to
Model No. PCS-XG55S for regulatory
compliance purpose.
WARNING
Use the AC power adapter provided with
this equipment as a power supply source.
Manufacture Type No.
Sony VGP-AC19V45
Sony VGP-AC19V15
Any other power sources may result in
hazards such as a fire.
Disconnect device of this equipment is the
mains plug of the AC adapter.
The mains plug on this equipment must be
used to disconnect mains power.
2
GB
Please ensure that the socket outlet is
installed near the equipment and shall be
easily accessible.
In the event of abnormal operations,
disconnect the mains plug.
NOTICE
Use the power cord set approved by the
appropriate testing organization for the
specific countries where this unit is to be used.
NOTICE
Each of PCS-XG80S/XG55S, PCS-RF1 and
PCSA-CXG80 contains an RF (Radio
Frequency) transmitting and receiving
module. Operation is subject to applicable
local radio communication regulations in
each country.
This equipment should be installed and
operated with minimum distance 20cm
between the radiator & your body. This
transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.
CAUTION for LAN port
For safety reasons, do not connect the LAN
port to any network devices that might have
excessive voltage.
Installing batteries
Two R06 (size AA) batteries are supplied for
Remote Commander.
To avoid risk of explosion, use R06 (size
AA) manganese or alkaline batteries.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
For the customers in the USA
WARNING
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.