Quax SOFIA Handbuch Seite 17

SOFIA
01 01 59xx
4. Assembling the babybed
Step 1 : Use both leg frames F, both sides G, eight bolts A and eight cylindrical nuts B
Place two bolts (A) in the provided openings on the upperside and the bottom of the leg frames (F). Insert
the sides (G) between the legstructures and pull the bolts one by one backwards and push them back into
the openings of the sides. The sides are now hanging free between the legs. Insert one by one the cylindri-
cal dowels (B) in the provided openings of the sides (G). Pay attention that the opening in the nut faces the
bolt. Tighten slightly with the hexagonal key (Ex1). Repeat this action for the remaining bolts.
Step 2 : Use the parts of step 1, the bottom H, four bolts A and four cylindrical nuts B or four bolts A, four
plugs D, four washers C and four cylindrical nuts E
Slide the bottom (H) in the bed. Lowest position : push a bolt (A) through the drilling of a leg frame into
the bottom. Push a cylindrical nut (B) in a provided opening underneath the bottom. Check if the hole in the
cylindrical nut faces the bolt. Tighten the bolt and repeat this operation for the remaining bolts. Middle and
highest position : push a plug (D) in the desired drilling of a leg frame, push a bolt (A) through the plug,
place a washer (C) and further into the bottom. Push a cylindrical nut (B) in a provided opening underneath
the bottom. Check if the hole in the cylindrical nut faces the bolt. Tighten the bolt and repeat this operation
for the remaining bolts Always fasten the bottom with the bolts in order to comply with the European
legislation. Finally tighten all bolts (A - step 1) fi rmly.
Step 3 : Changing the position of the bottom
Loosen all connections with the bolts (A - step 1). Unscrew the bottom, choose a new height and perform
step 2. Tighten the connections (A - step 1) back again.
Kinderbed 120x60 cm
Kinderbett 120x60 cm
Lit bébé 120x60 cm
Baby bed 120x60 cm
Quax Quax
® ®
First dreams First dreams
First steps First steps
17