Velleman CS5MXP Bedienungsanleitung Seite 13

DETECTOR NOT OPERATING ?
(a) Check the condition of batteries under load using the meter. (See Battery Check Procedure)
(b) Check that the search head is properly attached to the control box via the search head cable connector.
(c) Interchange batteries and ensures connections are correct and secure. Battery life can vary tremendously
between makes, therefore your 'new' batteries may already be insufficiently powerful to run the detector.
Oscillating Signal Accompanied By Slight Meter Fluctuation
(a) This could be due to poor battery connections. Ensure that they are tight and the batteries are securely clipped
into place.
(b) Loose search head cable connection - tighten.
(c) Interference from a vehicle using a radio transmitter or possibility a stationary source of electromagnetic
radiation - if this occurs then reduce the sensitivity. If the problem persists then the best remedy is to wait until
the transmission stops.
Intermittent Sound From Speaker
(a) This could be due to poor battery connections. Ensure that they are tight and the batteries are securely clipped
into place.
(b) Loose search head cable connection - tighten.
(c) Radio interference (see above).
The Detector Drifts Out Of Tune
(a) Temperature drift caused by change in air temperature when a machine is move from a house or car into the
open. The greater the change in temperature the more the drift, and in severe conditions up to 30 minutes
may be needed for the electronic circuitry to acclimatise itself.
(b) Sometimes battery drain can cause drift of signal. Replace batteries and this should help to maintain a stable
signal.
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulted from (incorrect) use of this device. For more info concerning this product, please
visit our website www.velleman.eu. The information in this manual is subject to change without prior
notice.
CS5MXP
- 13 - VELLEMAN