Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S3245
Safety
1. In case the square drive has a hole, always use steel pins and rubber rings, when
putting the impact socket on the square drive. When the square drive has a so-called
retaining ring, please always ensure that the retaining ring is in good shape and
when worn, it has to be replaced. A socket, which has not been secured in the 2
herefore-mentioned fashions, can be very dangerous and become a flying object!
Therefore we recommend never to use the impact wrench as a free running
instrument with socket attached.
2. Always use the special impact sockets.
3. An impact wrench should always be used just for loosening or tightening nuts.
4. The use of earprotection is advised.
Damages as a consequence of not following this manual, or caused by incorrect use or
incorrect repairs, will never be covered by our warranty and we will have no
responsibility for it. We reserve the right for technical improvements without prior
notification.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Straße 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de
Werbung
