Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing For Storage - Riverside FP25V Anleitung Und Teileliste

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

OPERATING INSTRUCTIONS
1. Use a strainer on the end of the suction line.
2. Make sure that all hose and pipe connections are air tight. An air leak
in the suction line may prevent priming and will reduce the lift capacity
of the pump.
3. Place the pump as close to the liquid to be pumped as possible. Keep
the pump and engine on a level foundation. When the suction hose is
hanging down a steep bank or into a hole, the weight of the hose and
the liquid in it can pull the pump into the liquid. To prevent "walking"
and the possible loss of the pump, tie it down.
4. In freezing weather, always drain the liquid from the pump after use
by removing the drain plug. In freezing weather, crank the engine very
slowly so you can feel whether the pump is free to run before you crank
to start the engine. If the pump is frozen, thaw it out slowly. Do not use
fire to thaw the pump.
5 Maximum volume is achieved by:
a. keeping lines as straight as possible, and avoiding kinks and
sharp bends.
b. making the vertical suction lift (distance from the water being
pumped to the pump suction port) as short as possible.
c. using large diameter suction and discharge lines (larger diameter
provides lower friction).
d. using as few connectors, elbows and adapters as possible.
e. maintaining the pump and associated equipment in good
operating condition.
6. If flexible hose must be laid across a roadway, protect it with planking.
Instantaneous shut-off pressures, applied when a vehicle runs across
an unprotected line, can cause damage to the pump and hose.
PROTECT LINE
WITH TIMBERS
7. The discharge hose used with the FP25 must be able to withstand a
maximum pressure of 150 PSI (10.34 BAR).
NOTE:
NOTE: All connections on the suction side of the pump must be air tight.
NOTE:
NOTE:
NOTE:

PREPARING FOR STORAGE

When product is to be stored or not used for a long period of time, the
pump should be prepared for storage:
1. Drain the pump. If the pump contains liquids which could dry out
and cake up, it is a good idea to pump a little clean water before
draining the pump.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: Flush with fresh water daily if pump is used in salt water.
2. Leave the drain plug out of the pump.
TO DRAIN, REMOVE PLUG
LIMITED WARRANTY
Riverside Pump Manufacturing Inc. warrants to the original retail purchaser that
this Riverside Pump Manufacturing Product is free from defects in material and
workmanship and agrees to repair or replace, at the discretion of Riverside Pump
Manufacturing, Inc., any defective Product free of charge within the time period
of Two Years
Two Years
Two Years
Two Years from the date of purchase.
Two Years
This warranty is not transferable and does not cover damage resulting from
defects other than in material or workmanship, or damage caused by
unreasonable use, including the failure to provide reasonable and necessary
maintenance. Also, the warranty obligations do not apply to conditions resulting
from misuse, alteration or accident. In addition, this warranty does not cover
replacement of non-defective parts (such as seals, wear plates and impellers)
that may wear and need to be replaced with reasonable use within the warranty
period or which may require replacement in connection with normal maintenance.
SAVE YOUR SALES SLIP
SAVE YOUR SALES SLIP
SAVE YOUR SALES SLIP
SAVE YOUR SALES SLIP
SAVE YOUR SALES SLIP
Proof of purchase in the form of your dated sales receipt, cash register slip, etc.
showing the serial number and the model of your Product will be required. You
must, at your own expense, arrange to deliver or ship the Product for warranty
repairs and arrange for pickup or return of the Product after repairs have been
made.
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
THIS WARRANTY DOES NOT APPLY TO ANY TRADE ACCESSORY OR ENGINE
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
WHICH IS SEPARATELY WARRANTED BY ANOTHER MANUFACTURER AND NOT
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
MANUFACTURED BY RIVERSIDE PUMP MANUFACTURING INC.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES.
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
ANY IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE,
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
MERCHANTABILITY OR OTHERWISE, APPLICABLE TO THIS PRODUCT, SHALL
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
BE LIMITED IN DURATION TO THE DURATION OF THIS LIMITED WARRANTY.
RIVERSIDE PUMP MANUFACTURING INC. SHA
RIVERSIDE PUMP MANUFACTURING INC. SHA
RIVERSIDE PUMP MANUFACTURING INC. SHALL NOT BE LIABLE FOR ANY
RIVERSIDE PUMP MANUFACTURING INC. SHA
RIVERSIDE PUMP MANUFACTURING INC. SHA
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. SOME
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.
NOT APPLY TO YOU.
NOT APPLY TO YOU.
NOT APPLY TO YOU.
NOT APPLY TO YOU.
HOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICE
HOW TO OBTAIN WARRANTY SERVICE
Warranty service can be obtained from a Riverside Pump Manufacturing Inc. dealer
or distributor authorized to make warranty repairs. If you need warranty service,
check first with the Riverside Pump Manufacturing dealer or distributor from whom
you purchased the Product, or call for the name and location of the nearest dealer
providing warranty service: 1-800-696-9005 or 1-843-537-5579.
Riverside Pump Manufacturing Inc. will not make any reimbursements for warranty
service, except to Riverside Pump Manufacturing Inc. dealers or distributors
authorized to make warranty repairs. You must present your sales receipt when
making any claim for warranty service.
This warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rights
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
which vary from state to state.
which vary from state to state.
which vary from state to state.
which vary from state to state.
3
LL NOT BE LIABLE FOR ANY
LL NOT BE LIABLE FOR ANY
LL NOT BE LIABLE FOR ANY
LL NOT BE LIABLE FOR ANY

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Fp25viFp25hFp25heFp25kFp25yFp25ye

Inhaltsverzeichnis