Mowing; Working Instructions; General Working Instructions; Setting The Cutting Height - Grizzly BRM 42-125 BS Originalbetriebsanleitung

GB
For your safety: Stand behind the
device when starting it.
Check the petrol and oil levels
regularly (see "initial operation")
and refill in time.
RUN
3x
Cold start:
1. Press the petrol pump (32)
(primer) 3 x.
2. Pull the safety loop (2)
towards the grip handle
(1) and hold it.
3. Pull the starter handle (7).
4. If the motor starts slowly, re-
lease the starter handle into the
starter rope-guide (3).
For a warm start it is not neces-
sary to press the primer (32).
If the primer is pressed too often, too
much petrol will enter the carburettor
and the motor is difficult to start.
Motor stop:
• Release the safety loop (2). The
motor switches off and the knife is
braked.
Knife stopping device:
Regularly examine the knife stopping
device: Release the safety loop (2). The
motor switches off and the knife is braked.
The knife must stop within 7 seconds.

Mowing

1. Start the engine (see
2. Hold the grip handle (1) and the
safety loop (2) with both hands
94
STOP
START
).
while mowing.
3. Wheel drive: (BRM 42-125 BSA)
On: Pull the drive catch (34)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (34)
The equipment stops.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as possible.
For uninterrupted mowing, the lines
should always overlap by a few centi-
metres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment for
damage. Restart work only if the equip-
ment is undamaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use, as
described in the "cleaning and mainte-
nance" chapter.

Setting the Cutting Height

The equipment has 5 positions for setting
the cutting height (25-37-50-62-75 mm):
1. Pull the lever (17) outwards and
push it to the desired position (33).
2. Push the lever (17) back in.