Notes On Safety; I Ncorrect Use - SUHNER MACHINING BEWI 6 Originalbetriebsanleitung

1. n
1.1 g
enerAl nOtes On sAfety
This operation manual is applicable for the machine BEWI
6.
The machine may only be handled by personnel
who are qualified.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
The machine is suitable for all machining operations
needing axial force and torque as well as extremely small
hole distances, like drilling and countersinking. This ma-
chine is specifically ideal for plant construction.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
I. Sebben. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Lupfig, 03/2019.
I. Sebben/Division manager
2. c
2.1 A
ssemBly instructiOns
Maximum admissible machine fastening
error.
The machine is fastened with the provided
clamping foot.
Screws of quality grad 8.8 must be used. The starting tor-
que for the holding down bolt is maximum 30Nm.
12
s
otEs on aFEty
ommissioning
Connect the power supply only after the machine
has been completely installed.
2.2 t
Aking the mAchine intO serVice
Clamp the machine the relevant holding fixture. Here,
ensure that the clamp area is not narrower than 20 mm in
order to prevent excessively high pressure being placed
on the bearing. Type SFI clamp feet are suitable for
clamping the machine.
2.2.1 s
elect the speed
Establish the desired speed and set it on the relevant
drive unit.
2.2.2 f
lexiBle shAft
Insert locking knob and hose coupling into the connec-
tion bore. Make sure that the locking knob snaps in.
2.3 r
Ating dAtA
Max. drilling capacity in steel 600 N/mm
Tool hoder: Collet chuck
Running trueness
Maximum speed
Weight
Flexible shaft connection
Required flexible shaft
2
Ø6mm
ER16
0.01mm
1
12000min-
1.450kg
G28
NA12