Bluetooth Pairing - Thrane & Thrane EXPLORER 500 Erste Schritte

BLUETOOTH PAIRING

NOTE: This section only describes how to pair devices in which you can enter a
passkey. For information on devices in which you cannot enter a passkey, such as
headsets, refer to the User Manual.
To pair a Bluetooth device, do as follows:
1. Start up the EXPLORER 500 as described in the beginning of this document.
2. Place your Bluetooth device close to the EXPLORER 500.
3. On your Bluetooth device, search for new devices and select the EXPLORER 500
when it is found.
The default Bluetooth name of the EXPLORER 500 is EXPLORER 500.
If there is more than one EXPLORER 500 in the list, you can use the MAC address
to locate the correct one. To see the MAC address of your EXPLORER 500, enter
the display menu system and select
PROPERTIES > TERMINAL > HARDWARE > MAC.
4. On your Bluetooth device, enter the passkey of your EXPLORER 500.
The default passkey is the serial number of your EXPLORER 500.
To see the serial number, look at the label on the back of the EXPLORER 500 or
enter the display menu system and select
PROPERTIES > TERMINAL > HARDWARE > UNIT SER. NO.
The new Bluetooth device is now paired and ready to communicate with the
EXPLORER 500.
NOTE: Maximum 7 devices can be paired with the EXPLORER 500. If you have
already paired 7 devices you have to unpair a device before you can pair a new
one. For information on how to unpair devices, refer to the User Manual.
GB