MaxPro PROFESSIONAL MPCD14Li/2E Bedienungsanleitung Seite 13

Torque settings(Tightening power of your drill)（Fig.3）
When using your drill for various driving applications, it becomes necessary to increase and decrease the
power and torque in order to prevent the possibility of damaging screw heads, threads, work pieces, etc
In general, power and torque should correspond to the difficulty of the screw to be driven. If torque is too
high, the screws can be damaged or broken
To Adjust Torque（Fig.3）
• Locate the arrow on the front of the drill housing.
• Identify the torque settings and 1 drill setting on the torque adjustment collar. • Rotate the torque
adjustment collar to the desired setting, aligning the required number on the torque adjustment collar with
the arrow on the drill housing.
• To increase or decrease torque, rotate the torque adjustment collar. The lower the number, the lower the
torque setting. The higher the number, the higher the torque setting.
Always check that the correct torque is selected by practising on scrap material prior to carrying out a job.
The torque setting required to drive screws will differ with different materials. Start with the torque setting
on the number you think is appropriate and simply increase the torque adjustment collar to a higher
number if the screw head is not sitting flush with your work piece. Remove the screw after adjusting and r
e-drive the screw back into the work piece until the correct torque adjustment leaves the screw head flush
with your work piece.
Spindle Lock Function
When spindle lock is selected ,the motor´s spindle is locked and so the chuck and screwdirver or drill bit
cannot turn.
That the chuck and bit are automatically locked when the speed control trigger is released.
Keyless Chuck
A keyless chuck is included on your drill to allow for easy installation and removal of bits/accessories. The
chuck is divided into two parts. The rear is called the collar and the front is the body.
To open and close the keyless chuck, grasp and hold the collar of the chuck with one hand and rotate the
chuck body with your other hand.
The arrows on the chuck indicate in which direction to rotate the chuck body in order to GRIP (tighten) or
RELEASE (unlock) the drill bit.
Warning! Do not hold the chuck body with one hand and use power of the drill to tighten or loosen the
chuck jaws. The chuck body could slip and your hand could come in contact with a rotating accessory. This
could cause an accident resulting in personal injury.
Changing the Direction of Rotation（Fig.4）
The direction of rotation can be changed with the forward/release selector, this is located above the
variable speed switch.
To select the forward drilling position, push the forward/reverse selector hard left. To select the reverse
drilling position, push the forward/reverse selector hard right
The variable speed switch can be locked off by pushing the forward/reverse selector into the middle of both
the forward and reverse positions.
Do not change the direction of rotation while the keyless chuck is in motion
DRILL OPERATION
The Variable Speed Switch（Fig.5）
Turn the drill ON by depressing the variable speed switch
To turn the drill OFF release the variable speed switch
Speed Control（Fig.6）
The drill has a 2-speed gearbox, the speed selector(3) is located on the top of the drill. First gear has a
range of 0-350/min, second gear has a range of 0-1100/min. the speed can be varied from 0 to maximum in
switch. This way you can select the best possible speed for the job required
LED Lights
The drill has 1 LED light built into the unit. The LED light is located above the variable speed switch.
The LED light turns on automatically when you depress the variable speed switch.
The LED light illuminates dark areas in tight corners to assist with drilling and screw driving. This helps
achieve a more accurate result in your workpiece.
6 GB