Alpina PLUG-IN-LIGHT III Anleitung Seite 7

to ensure that the battery is fully charged on delivery. This film can
simply be pulled out. The light is switched on and off by pressing
on the push switch and offers a number of different functions (figs.
2–5). Press once to turn the light on; the red light is lit continuously.
Press twice to put the light into flash mode. Press a third time to
deactivate the light. Please note that the battery of the LED rear light
can fail or become drained. You should therefore check regularly
that the light is working. Parents should also ensure that their
children regularly check the functionality of their LED rear light.
The LED rear light is not a toy and should not be used by children
except under the supervision of an adult. Symbols shown on the
product: You will see a number of symbols on the product (figs.
10–14). Fig. 10: Declaration of conformity: products labelled with
this symbol meet the requirements of the CE Marking Directives.
Fig. 11: Dustbin: the product must not be disposed of as household
waste; it should be taken to a local collection point or recycling
centre. Fig. 12: Indicates the type of protection against penetration
of solids and liquids. Fig. 13: Indication of battery type and voltage.
Fig. 14: Indication of Class 3 protection for low-voltage electrical
appliances. Changing and disposing of batteries: To change the
battery, first detach the light from the helmet (fig. 1). Now remove
the cover plate for the light by carefully sliding the rubber edging
to the side to allow the plate to be removed (figs. 6–7). Take out the
circuit board (fig. 8). The battery is located on the reverse side of the
circuit board (fig. 9). You can now slide it out. Only use replacement
batteries of type CR 1620 – 3V (fig. 13). This battery is commonly
available and can be purchased from any good electrical appliance
store. Please note that the battery must only be replaced with a
battery of the same type and voltage. To insert the new battery go
back in reverse order through the steps for removal. Notes: Battery
replacement must be carried out by an adult. Check the polarity of
the battery when inserting. Do not attempt to recharge batteries and