Inhaltsverzeichnis
Werbung
20
EUROLIVE B115D/B112D
EUROLIVE B115D/B112D Getting started
Step 3: Getting
(EN)
started
Place the speaker(s) in desired locations,
either on stands or as wedge monitors
on the floor.
Make all necessary connections.
DO NOT turn on the power yet.
Turn on your audio source
(mixer, microphone).
Turn on your speaker(s) by pressing the
POWER SWITCH. The POWER LED will
light up.
Play your audio source or speak into your
microphone at a normal to loud level.
Adjust the LEVEL knob to the desired
volume. If the CLIP LED flashes,
turn the LEVEL knob down. If using
multiple speakers, the LEVEL knob must be
adjusted on each speaker.
If necessary, adjust the HIGH and
LOW EQUALIZER knobs on each speaker
to boost or cut treble and bass
frequencies to taste.
Optional wireless microphone set-up
Only insert the optional BEHRINGER
DIGITAL WIRELESS microphone
receiver into the input.
Turn the ON/OFF switches on the
microphones to the "ON" position.
During the pairing process, the LED on
the dongle will flash. Once the
connection between the wireless
microphone and the receiver is achieved, the LED
will remain on (solid).
Speak into the wireless microphones
and adjust the volume using the volume
buttons on the individual microphones.
Press the volume down button for two seconds to
mute the microphone signal. Press the volume up
button to unmute the microphone.
Werbung
Inhaltsverzeichnis
