Halley Home Run 1.0 Bedienungsanleitung Seite 21

FUNCTIONS
· SPEED: Displays the training speed. Speed range: 1.0-10 km/h. In the manual program the initial rate is 1.0.
In automatic mode, the speed up/slow down key is invalid.
· TIME: Displays the training time. The default setting is 10 minutes. When you start exercising, the timer starts counting
down to 0.00. The time range is from 5.00 - 30.00 minutes.
· DISTANCE: Displays the distance covered during the session between 0.00 and 99.99 km.
· CALORIES: Displays calories burned during exercise, in values from 0 to 999..
BUTTONS
· MODE: Press the key to start the computer menu and confirm the settings. Press it to change display mode (SPEED, TIME,
DISTANCE,CALORIES)
· Up-Down: To adjust settings and navigate through the computer menus, turn the button. Quickly adjusts the speed and
settings that are flashing on the screen.
· ON/OFF: Press the key to switch on the computer. If you press ON/OFF during the session, the treadmill will stop and the
display will go into standby mode. To resume the session, press ON/OFF.
· Safety Key: The equipment does not work without the safety key. If the safety key is removed during the session, the
treadmill will stop.
ERRORS
Screen not working
CAUSE: There is a problem with the connection between the computer and the controller.
SOLUTION: Check the four-pin connector cable between the computer and the controller is not loose or
defective.
CAUSE: Switch may be off.
SOLUTION: Turn on the switch.
Working speed can not reach the settled speed
CAUSE: Voltage may be low.
SOLUTION: Wait until the voltage is normal.
Home Run 1.0
21