completing the push rods as shown in the picture. The pushrods for the elevator and the rudder are shown
pieces and only symbolically.
Schritt 11 / Step 11
Alle Anlenkungen mit den
Servo- und den Ruderhebeln
verbinden und mit den
Messingbolzen sichern.
Secure all push rods on the
side of the servo horn and on
the side of the rudder control
horn with brass pin as shown
in this picture.
Schritt 12 / Step 12
Antriebseinheit auf den
Motorträger schrauben und
mit Sekundenkleber
befestigen, Regler auf der
Unterseite ebenfalls am Rumpf
festkleben.
Screw the motor on the holder
and glue on the unit. Also glue
on the ESC to the bottom part
of the fuselage.