Possible Faults; Technical Data - ATIKA HKM 800 Originalbetriebsanleitung

Before each fault elimination:
wait for standstill of the beater

After each fault clearance, put into operation and recheck all security installations.
Problem
The device does not sweep
properly
The circular brushes (11) do
not turn
The brush rollers (22) do not
turn
The device is difficult to ma-
noeuvre
Type / Model
Year of construction
Drive
Sweeping capacity
Working width
Circular brushes
Brush roller
Debris container (capacity)
Weight
Please observe the enclosed terms of guarantee.

Possible faults

Possibel cause
⇒ Walking too slowly or too fast
⇒ Debris container (10) full
⇒ Height of the circular brushes (11)
and/or the brush rollers (22) set too
high
⇒ Circular brushes (11) and/or brush
rollers (21, 22) heavily worn
⇒ Short belt (16) and/or long belt (18)
jumped off or torn
⇒ Middle belt (17) and/or long belt (18)
jumped off or torn
⇒ Height of the circular brushes (11)
and/or the brush roller (22) set too low
⇒ Guide roller (20) dirty or defective

Technical data

Guarantee
Remedy
⇒ Push the device at normal walking speed (approx.
4 km/h) ahead of you.
⇒ Empty the debris container (10)
⇒ Set the correct height of the brushes (11, 22) with
the adjustment knobs (12, 13)
⇒ Replace the circular brushes (11) and/or brush
rollers (21, 22)
⇒ Tension short belt (16) and/or long belt (18) or
replace
⇒ Tension middle belt (17) and/or long belt (18) or
replace
⇒ Set the correct height of the brushes (11, 22) with
the adjustment knobs (12, 13)
⇒ Clean or replace the guide roller (20)
HKM 800
see last page
manual
3200 m²/h (at 4 km/h)
800 mm
Ø 270 mm
Ø 150 mm x 440 mm
30 l
12.7 kg
11