Technical Data - REV 93238 Montage- Und Bedienungsanleitung

GB

TECHnICAL DATA

• Voltage:
• Type:
• Illuminant:
• Luminous flux:
• Colour temperature:
• Protection class:
InSTALLInG THE HAnDLE AnD BASE (see 1 and 2)
• Loosen the wing nut on the support and insert the base into the handle.
Insert the wing nut into the hole provided on the handle and tighten it.
SETTInG THE FLOODLIGHT DIRECTIOn
• Loosen the screws on the sides underneath the housing and adjust the
floodlight direction – ensure that the handle is not illuminated – and then
retighten all screws.
The floodlight is now ready for use and can be operated under the intended
conditions – it is essential that the requirements specified under "General
Safety Instructions" in regards to the installation location are followed.
CLEAnInG
• Before cleaning the halogen floodlight, disconnect the power cable and
allow the floodlight to cool down sufficiently.
8
ponds, or similar bodies of water.
• must not be immersed in water or other liquids.
• must not be operated with wet hands; never look directly into
the light source.
• must never be covered.
• must never be operated with an open housing, missing or
damaged wiring compartment, or missing or damaged lens.
• must never be left unattended while in operation or in the
cooling phase.
• must never be left unattended in the vicinity of children.
• must never be sprayed or cleaned using a steam pressure
cleaner since this can damage the insulation and seals.
• must never be repaired by the user. Repairs must only be
carried out by the manufacturer or an authorized service
representative.
230V~, 50Hz
93238
20W LED Chip
approx. 1400lm
6500K
IP44