Parts Description; Before The First Use - TriStar VE-5962 Bedienungsanleitung

• Make sure that the cord is not hanging over the edge of the table
or counter, does not touch any hot surfaces or is coming directly
into contact with the hot parts of the appliance. Do not place the
appliance underneath or close to curtains, window coverings etc.
(*) Competent qualified electrician: after sales department of the
producer or importer or any person who is qualified, approved
and competent to perform this kind of repairs in order to avoid
all danger. In any case you should return the appliance to this
electrician.

PartS dEScriPtion

1. Control knob for oscillation and ventilation
2. Front base
3. Rear base
4. 3 screws
4
1
2
3
4

BEforE thE firSt uSE

• Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
• Take the three screws out of the base.
• Pull the cable through the two feet halves and then click the two
halves together.
• Screw the base plate by using the three screws under the fan.
• Press the power cable into the appropriate notches below the base
plate.
• Check if the voltage of the appliance corresponds to the main
voltage of your home. Rated voltage : AC220-240V 50Hz.
• Place the fan always on a flat and stable surface and make sure
there is 10 cm. of free air around the fan. This device is not suitable
for installation or outdoor use.
uSE
Use the control knob to choose the following different options.
You can choose out of 3 different ventilation levels with or without
oscillation.
off StoP
1. Low ventilation level
2. Medium ventilation level
3. High ventilationlevel
Low oscillation level
1
Medium oscillation level
2
3
High oscillation level