Kenwood KVT-M707 Installations-Handbuch Seite 4

Connection
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
E
+
Antenna Cord
Accessory 0
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal when using the
optional power amplifier, or to the antenna control terminal in
To "EXT.AMP.CONT. " terminal of the amplifier having the external
4
|
English
To vehicle's reverse lamp harness
To Steering remote
D
A
B
C
FM/AM antenna input
Accessory 4
If no connections are made, do not let
the cable come out from the tab.
the vehicle.
amp control function.
Parking sensor wire (Green)
Reverse sensor wire (Pink)
Steering remote control input
(Light Blue/Yellow)
Dimmer control wire (Orange/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) -
AV OUTPUT
AV INPUT 2
L R L
VIDEO
FM /AM ANTENNA AV INPUT 1
L R R
VIDEO
Mute wire (Brown)
Power control/ Motor antenna control cable
(Blue/White)
External amplifier control wire (Pink/Black)
Monitor unit
Accessory 3
PRK SW
REVERSE
REMO.CONT
ILLUMI
ACC (5A)
BATT
Receiver unit (front side)
SUB PRE OUTPUT
REAR FRONT
L L L
R-CAM V-IN
POWER
VIDEO R R R
Accessory 1
MUTE
ANT. CONT
P CONT
EXT.CONT
(10A)