hanseatic WQP12-J7609D Gebrauchsanleitung Seite 63

The dishwashing results are not satisfactory
Problem Possible cause
There are residues The rinse aid is incorrectly
or streaks on the dosed.
dishes.
There is no dishwasher salt. Add dishwasher salt (see „Adding dish-
The dishwasher salt is
clumpy.
The dishes are not There are food scraps
completely clean. which are encrusted onto
the dishes.
The dishes have not been
stacked optimally.
You have selected the
incorrect dishwashing pro-
gramme.
The dishwasher detergent is
incorrectly dosed.
The water pressure is too
low.
The spraying arm can not
rotate unhindered.
The nozzles on the spraying
arm are blocked/calcified.
Only one spraying arm is
active.
Troubleshooting table
Solution
Adjust the dosage (see „Adding rinse aid"
on page EN-11)).
washer salt" on page EN-12).
Stir the dishwasher salt using the end of a
spoon or similar.
Soak dirty dishes prior to washing the dish-
es.
Stack the dishes in such a way that all
parts can be reached by the water jets
(see „Loading the dishwasher" on page
EN-13).
Select the correct dishwashing programme
(see „Dishwasher programme table" on
page EN-16).
Also select the additional option "Intensive
dishwashing" (see page EN-18).
Use the correct dosage of dishwasher
detergent (see „Dishwasher programme
table" on page EN-16).
Turn the water tap on completely.
Ensure that no dishes are impeding the
motion of the spraying arm.
Clean the nozzles (see „Cleaning the
spraying arm" on page EN-21).
See „Selecting a spraying arm" on page
EN-17.
Page EN-29