Charging - SXT-Scooters 500 EEC Bedienungsanleitung

Your scooter comes charged out of the carton. We still recommend charging
the unit for 6-8 hours prior to it's first use. We also recommend charging
your scooter after each use and prior to storage.
WARNING: Do not allow your scooter to go into deep discharge, as this
will damage the batteries.
1. Make sure that all of the exposed bolts and screws are tightened.
2. This scooter model has a safety switch at the kickstand. If kickstand is
down this scooter model cannot be operated as the electricity is cut automati-
cally for safety reasons.
3. Push the on/off switch (located on the left handlebar) to the ON position.
4. Put one foot on the deck of the SXT while pushing off with the other foot,
gently rotate the THROTTLE GRIP, on the right side of the handlebars. The
scooter will begin to move on its own power.
**Your scooter has a variable speed hand throttle. You can control the
speed of your scooter by the amount of pressure you use when rotating the
hand throttle. The more you rotate, the faster you will go.

CHARGING

1. 1. Make sure unit is turned off.
2. Open the charging socket cover located on the right
side of the scooter frame, under the footplate.
3. Locate your Battery Charger. Find the charger socket
end that has a three-prong socket and plug it into the
scooter.
4. Next, plug the AC plug into a wall outlet.
When first plugged in, the charger has one red light that
will illuminate at the same time, indicating that the char-
ging process has started. Once the light on the charger
turns red & green, you may remove the charger and close
the safety cap.
7
instuctions sxt-scooters