Altrex Get-Up Anleitung Seite 28

General instructions
Safe use of telescopic ladders
• Never stand higher than on the last unmarked rung.
• Do not stand on the ladder for a long time without taking breaks regularly
(tiredness entails risks).
• Prevent transport damage, for example, by laying down the ladder properly.
• Only use a ladder that is suitable for the job.
• Do not use a 'dirty' ladder e.g., soiled by wet paint, mud, oil or snow.
• Do not use the ladder during bad weather, such as during high winds.
• A risk analysis, according to the applicable legislation of the country in which the ladder is
used professionally, must be carried out.
• During positioning the ladder, consider the risks of collusions e.g., by pedestrians, vehicles or
doors. If possible, secure windows and doors (except emergency exit doors) in the work area.
• Use non-conductive ladders for unavoidable work on electricity.
EN EN
• Do not modify the design of the ladder.
• Do not move the ladder with someone standing on it.
• Always place ladders on their feet and not on a rung.
• During work activities, always keep both feet on a rung of the ladder and always face
the ladder.
2. Straight ladder position (+ Chapter 1)
• While using a ladder without an imperial; always start extending the ladder from the bottom.
28
Always use the ladder with rungs
at the correct angle.
Ladders used to access a higher
level, must protrude at least 1
metre above the landing point and
if needed, should be secured.
Do not lean the ladder against
unsuitable surfaces.
Use the ladder with steps only if
the steps are horizontal.
Use the ladder only in the
indicated direction (only applicable
if the design of the ladder makes
this necessary).
Do not stand on the marked
rungs.