Installing The Product; Using The Product - nedis HHEM300WT Kurzanleitung

• Keep cells and batteries clean and dry.
• Only use the provided charger and charging
base.
• The product is delivered with a partially charged
battery. For optimal battery life, fully charge the
battery before first use.
• Secondary cells and batteries need to be charged
before use. Always use the correct charger and
refer to the manufacturer's instructions or
equipment manual for proper charging
instructions.
• Do not leave a battery on prolonged charge
when not in use.
• After extended periods of storage, it may be
necessary to charge and discharge rechargeable
cells or batteries several times to obtain
maximum performance.
• Do not unplug the product by pulling on the
cable. Always grasp the plug and pull.

Installing the product

Make sure the product is placed on a flat and
4
stable surface.
1. Push the handle tube A
When the parts are successfully assembled, you
hear a click.
2. Place the product on the charging base A
3. Plug the power adapter A
4. Plug the other end of A
A
d .
Charge the battery for at least 3.5 hours when
4
you use it for the first time.
5. The battery indicator LED A
6. Remove A from the power outlet after
s
charging.
7. Leave the product on A
Battery indicator LEDs (image B)
The lowest battery indicator LED A
4
flashing if the battery is empty.
Removing and filling the clean water
reservoir (image C)
1. Hold the handle A
1
water reservoir handle A
to remove the clean water reservoir A
2. Pull out the water inlet plug A
to one side.
into the body A
4 6
f .
into a power outlet.
s
s into the charging port
lights up.
p
f .
p starts
with one hand, and pull the
q with the other hand
r .
and rotate A
e
3. Add cold or warm tap water to A
4. Do not exceed the MAX indicator A
5. Close A
e
6. Place A
r
The product is delivered with a partially charged
battery. For optimal battery life, fully charge the
battery before first use.

Using the product

Test the water resistancy of the floor.
4
This product is intended to clean dust and liquids
4
off waterproof hard floors such as. PVC, linoleum,
tiles and waxed parquet.
This product is not intended to clean water-
4
sensitive floors such as untreated cork floors.
Make sure the clean water reservoir A
4
with water and the dirty water reservoir A
installed in the product.
Clean the floor from the inside out to avoid
4
leaving footprints on the freshly wiped floor.
To avoid damaging the floor with a wet roller
4
brush A
9
base A
f
.
1. Clean the floor with a vacuum cleaner to remove
dust or loose particles.
2. Take the product out of A
3. Press the on/off button A
product.
The roller brush A
4. Press the water spray button A
5. Move the product back and forth until A
fully wet.
6. Clean the floor by moving the product back
and forth at the same speed as using a vacuum
cleaner.
7. Press A
2
8. Place the product on A
9. Press the self-cleaning button A
A
9 starts to rotate.
The self-cleaning function removes the dirty
4
water from A
10. Empty and clean A
cleaning the dirty water reservoir' .
11. Clean A
9
e
7
r
.
into A
6 .
, place the product into the charging
when the product is not in use.
f .
2 to switch on the
9 starts to rotate.
3
to switch off the product.
f .
o
.
9
. See 'Emptying and
i
. See 'Cleaning the roller brush' .
via the hole.
.
w
r is filled
i is
.
9 is
.