Cable Connection - PROLUMIA ROCKDISC III Gebrauchsanleitung

MOUNTING
1. Loosen the screws and remove the light unit.
2. Pull the power cord through the gasket.
3. Fix the fixture on the surface with screws. (Pay attention to the direction with the
marking 'UP' on the base.)
4. Connect the power cord on the terminal correctly. (Caution: The earthing cable must
be connected firmly.)
5. Connect the male connector of the light unit to the female connector on the base.
6. Assemble the light unit firmly. (Pay attention to the alignment.)
5
4
2

Cable connection

MAINS POWER SUPPLY
Remove in Master/Slave use
Without sensor
3
5
3
With sensor (switched phase not required)
www.prolumia.com
1
MAINS POWER SUPPLY
6
15