Lionelo Noa Plus Bedienungsanleitung Seite 8

Step 2: remove both straps from the baby seat and uncouple them (fig. 4).
Step 3: run the straps through the proper holes. Make sure that both straps are
installed at the same height and they are not twisted.
5.2.1 Loosening the straps
Step 1: Press the button located under the seat, at the front of the baby seat.
Step 2: While holding the button, pull the shoulder straps to loosen them (fig. 5).
5.2.2 Securing a child in the baby seat (fig. 6)
When the shoulder straps are properly adjusted to the height of your child, please
complete the following steps:
Step 1: Unfasten the buckle and put the straps apart so that they don't block the
seat. Then, place your child in the baby seat.
Step 2: Run the shoulder straps over the baby's shoulders and put the two metal
connectors together, as shown in the picture 1.
Step 3: Insert the joint connector into the buckle, as shown in the picture 2. The
"click" sound indicates that the connector has been properly locked in the buckle.
Step 4: Pull the shoulder straps to make sure that they are properly secured in
the buckle, as shown in the picture 3.
5.2.3 Tightening the straps
Pull the shoulder straps up so as to stretch them out. Then pull the adjustment
strap to tighten the harness (fig. 7).
The shoulder straps should be neither too tight nor too loose so as not to cause
discomfort to the child.
5.3 Securing the baby seat
In order to properly mount the baby seat in a car, please refer to the corresponding
information in the vehicle's manual.
Do not mount the baby seat in a vehicle's front car seat with active airbags.
This baby seat can only be secured in a car with a 3-point seat belt.
The baby seat must be installed in a rear-facing position.
Step 1: Move the lever to the extended position. Place the baby seat on the car
seat. The handle must be rested on the back of the car seat (fig. 8a).
Step 2: Run the belt through all guides of the baby seat. Lock the belt connector
EN ‑ 8 ‑