Vitrifrigo IM CL Montage-, Bedienungs- Und Wartungsanleitung Seite 38

11.1 THE APPLIANCE DOES NOT WORK
Check that:
− it is energised.
− the "STAND-BY" switch D1 is active and the LED is on.
− the automatic circuit breaker of the electrical system is not disconnected.
− the plug is efficient and correctly inserted into the socket and the power
outlet works. For this verification, connect to the socket a device whose
functioning is certain.
− the supply cable is not interrupted.
11.2 NOISY ICE MAKER
Check that:
− the ice maker is on a level surface.
− the ice maker is not in contact with furniture that can could cause vibrations.
− the refrigerant circuit pipes located on the back have no contact points and
do not vibrate against the appliance.
11.3 ICE MAKER WITH INSUFFICIENT PRODUCTION
Check that:
− the door closes hermetically.
− the ice maker is not near heat sources.
− the ice maker is sufficiently ventilated.
− the condenser is not clogged with dust.
− the fan turns freely.
11.4 THE ICE MAKER DOES NOT MAKE ICE
Check that:
− the refrigeration system is in operation and produces cold.
− there is water in the ice cube tray (A).
− the water system is efficient.
− there is sufficient water in the tank (Refill version)
− keys D1 and D2 are active
− the internal temperature in the cell is approximately ≤ -15°C.
− the ice level sensor (B) is in the position shown in fig.4
− if there is water in the ice cube tray, check the functionality of the
refrigerant system (H).
− there is no cube stuck in the ice cube tray.
11.5 THE ICE MAKER DOES NOT DISPENSE ICE
Check that:
− there is ice in the ice cube tray.
If there is, reset the system by switching it off for ~4/5 hours.
If you do not manage to achieve regular operation after these checks,
contact the customer assistance service.
EN