Technoline WT 486 Bedienungsanleitung Seite 11

SNOOZE OPERATION (default snooze duration is 5 minutes)
When alarm is sounding, press
the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode,
the second alarm overrides the first alarm (the first alarm is reset to come on the next day).
USING THE HI-LO DIMMER
Press to select the LED brightness (high- / low-dim) of the LED display. This can only be
done when the radio is off.
ADJUSTABLE LOW-DIM BRIGHTNESS
When low-dim brightness is selected, turn the knob at the right side to adjust your desired low-dim
brightness. Rotate the knob downwards to reduce and upwards to increase the Lo-dim brightness.
Note: High LED brightness is not adjustable.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
LISTENING TO THE FM RADIO

To turn on the radio, press RADIO/SLEEP o c , h
radio frequency readings in Mhz.

Press /
next clear station.

To adjust the volume, press VOL o c , h
volume from L00 (sound off) to L15 (maximum).

Press
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may
cause interference to the radio.
USING THE PRESET MEMORY (UP TO 10 PRESET STATIONS)
This clock radio features a total of 10 preset memories of FM stations. These allow you to preset
your favorite stations and access them quickly.

Turn on the radio and select a radio station you like to memorize.

Press and hold the SET u
store Memory 1.

Press or
u "MEM" LED appears
once to store Memory 02.

Repeat Step 2 to 3 to preset memories 3 through 10.

To access a preset station at any time, press the SET one at a time while the radio is on.

To edit a preset station, select another station and then repeat Step 2 to 4. This overrides
the original settings.
USING THE SLEEP TIMER

At Radio mode, press and hold RADIO/SLEEP to enter the sleep mode. The SL LED
h
appear

Press the RADIO/SLEEP again as needed to adjust the sleep timer from 5, 15, 30, 45, 60,
75, 90 or OFF.

When the display changes back to show the time, press and hold RADIO/SLEEP to show
the sleep time remaining.
to tune the radio to a desired station. Press and hold
to turn off the radio.
"MEM" LED pp
to select another station you like to memorize. Then press and hold SET
"P01" f
p m "05" (5 m u
once, the alarm will be silenced and come on again after
p y ho
r
h . Pr
) appear on the display.
GB 4
p y ho "ON"
/ to scan for the
"L06", press
"P01" f h . Pr
o c , "P02" flashes. Press SET
h h
/ to adjust
SET once to