Intended Use; Improper Use - Inline SmartHome 40161 Bedienungsanleitung

6. INTENDED USE

The InLine® SmartHome fan generates a cool air-
fl ow through a fast rotating propeller.
The control is done either on the device itself or
via APP, if a successful integration into the WiFi
network has taken place.

7. IMPROPER USE

Improper use within the meaning of foreseeable
misuse applies:
• Do not disassemble the device.
• Only use the device inside, not outside.
• Do not expose the device to excessive heat.
• Do not subject the device to vibrations.
• Do not place the device within the reach of
children and/or pets.
• Do not place the device at an angle.
Do not insert any objects or put your
fi ngers through the front and/or rear
grille during operation, there is an
acute risk of injury!
8. OPERATION OF THE
INLINE® SMARTHOME FAN
PREPARATION
1. Place the device on a fl at, stable surface.
2. Insert the plug of the power cable into the
socket.
3. The standby LED lights up blue.
info@inline-info.com
9. MANUAL OPERATION VIA KEYS
SPEED
Briefl y press the power button to turn on the de-
vice. A short beep acknowledges that the device
is switched-on. The fan now rotates to speed le-
vel 1, the status LED „1" lights up blue.
To increase the speed to level 2, press the speed
button briefl y, which is confi rmed by a short beep.
The status LED „2" now lights up.
To increase the speed to level 3, briefl y press the
speed button again, which is confi rmed by a short
beep. The status LED „3" now lights up.
When the speed button is pressed again, the
speed decreases to level 1.
SLEEP MODE
If you press and hold the speed button for about
3 seconds, the fan switches to sleep mode, con-
fi rmed by a short beep and the sleep mode LED
lights up. In this mode the speed is automatically
reduced by one level after 30 minutes and then
remains at level 1. To deactivate the sleep mode,
press the speed button again for about 3 seconds
until the beep sounds and the sleep mode LED
goes out again.
TIMER FUNCTION
To activate or change the timer function, briefl y
press the timer button until the desired opera-
ting time (1 hour / 2 hours / 3 hours / 4 hours) is
selected. Each time a change is made, the beep
sounds and the respective LED lights up blue (if
the timer is selected for more than 3 hours, both
LEDs 1H and 2H light up simultaneously).
3