Maintenance - Jula 071026 Gebrauchsanweisung

6. Push the trigger catch forwards and squeeze the trigger.
The speed of the tool increases the longer the trigger is
squeezed. The tool begins to rotate.
Lubricate the tool with pneumatic oil (not supplied) every day or before each use.
Compressed air oil is available from well-stocked hardware stores. SAE 10 oil, sewing machine oil or
similar, with moisture absorber, corrosion inhibitors, metal wetting agent and EP additives can be used.
Do not use flushing oil.
During continuous operation, the tool must be lubricated every hour or two. The tool can be lubricated
with a line-mounted lubricating device or manually. Follow the instructions below for manual lubrication.
1. Disconnect the compressed air supply.
2. Apply a few drops of pneumatic oil in the
tool's air intake. Do not use oil with a high
viscosity. This can impair tool performance.
3. Connect the tool to the compressed air supply. Operate the tool with no load for a few seconds to
distribute the oil. Any surplus oil may be thrown out from the chuck. Aim the tool in a safe direction.
ENGLISH

MAINTENANCE

35