Combinations
By removing the middle strip or and
for smaller cars + , the rear seat
cover can be adjusted to the width of the
seat.
Step 12 – Fitting the side parts
Divide the supplied side parts by
•
fully
opening
connecting a side part to the base
part (see diagram).
Step 13 – Finishing off
Pull the finished parts over the car
•
seat and fasten the parts under
the seat by pulling the supplied
strap fastener through the rubber
loops. Stretch the strap and tie up.
Step 14 – Fitting the headrest cover
Mark the openings for the headrest holders on the top of the cover. Cut small holes in the cover with a
sharp knife and fit the headrest (see also item 8 in these instructions).
Recommendation: Dry-clean, do not tumble dry.
the
zips
and
MAINTENANCE
ENGLISH
18