Jula 605010 Gebrauchsanleitung Seite 17

Step 7
• Fasten the hook under the seat.
Step 8
• Mark the openings
headrest holders on the top of the
cover. Cut small holes in the cover
with a sharp knife and fit the
headrest.
Step 9 – Divided seats
• Check if the rear seat can be
divided. It can be divided in
different ways:
NOTE:
If the rear seat cannot be divided
•
you will not need the side parts.
We recommend, however, that
you save them and any other
parts for future use.
Step 10 - Headrest
Remove the headrest.
•
(You will find technical information
on how to do this in the service
handbook for your vehicle, or
contact your dealer.)
Step 11 – Fitting the rear seat covers
• Start with the seat part. Establish
the width of the rear seat cover by
spreading the whole base part on
the seat in the car. This will easily
allow you to see which middle
strips must be removed to adjust
the cover to
Remove the middle strips not
needed by opening the zips. The
rear seat cover
prepared for the maximum width
of a car.
for the
the rear seat.
is already
ENGLISH
17