LIVARNO Z30614A Montageanleitung

Kids' storage unit
©
Introduction
Before assembling and using the product
for the first time, take time to familiarise
yourself with the product first. Read the
following assembly instructions and safety instructions
carefully. Only use the product as described and
for the designated areas of application. Please
keep these instructions in a safe place. If you hand
this product on to a third party, you must also pass
on all documents relating to the product.
©
Intended Use
This product is intended for the keeping of small
and lightweight objects in an interior domestic envi-
ronment. Any use other than previously mentioned
or any product modification is prohibited and can
lead to injuries and / or product damage. The man-
ufacturer is not liable for any damages caused by
any use other than for the intended purpose. The
product is not intended for commercial use.
©
Description of parts
Side I
1
Side II
2
Back
3
Top
4
Bottom
5
Division I
6
Drawer front
7
Drawer bottom
8
Base trim
9
Drawer back
10
Drawer side
11
Wooden handle
12
Retainer
13
Phillips screw (ø approx. 3 mm x 12 mm)
14
Camlock pin (ø approx. 6 mm x 40 mm)
15
Camlock
16
Wooden dowels
17
56153_liv_Schubladenschrank_content_LB4.indd 3
All manuals and user guides at all-guides.com
18
19
20
21
22
23
24
©
Dimensions:
Material:
©
Note: Take care when unpacking that you do not
inadvertently throw away any assembly material.
Immediately after unpacking, check that the delivery
is complete and that the product and all its parts are
in perfect condition. Do not under any circumstances
assemble the product if the delivery is incomplete.
14 Drawer sides
36 Wooden dowels
56 Phillips screws (ø approx. 2.5 mm x 25 mm)
Screw hook
Phillips screw (ø approx. 4 mm x 25 mm)
Phillips screw (ø approx. 2.5 mm x 25 mm)
Dowel
Back panel stabiliser
Antiscratch pad
Division II
Technical data
approx. 23 x 86 x 19 cm
(W x H x D)
MDF board
Supply Scope
1 Side I
1 Side II
1 Back
1 Top
1 Bottom
4 Divisions I
7 Drawer fronts
7 Drawer bottoms
1 Base trim
7 Drawer backs
7 Wooden handles
7 Retainers
4 Phillips screws (ø approx. 3 mm x 12 mm)
8 Camlock pins (ø approx. 6 mm x 40 mm)
8 Camlocks
1 Screw hook
7 Phillips screws (ø approx. 4 mm x 25 mm)
1 Dowel
Introduction
GB 3
15.12.10 09:46