Werbung
SK
16
The brakes must be engaged at all times when the stroller is not moving.
−
Getting over the curb practice firstly with an empty stroller.
−
The attendant must take precautions against the fire risk. In buildings, check the location of
−
fire exits and ensure procedures are understood.
Do not let children play with or hang on the stroller.
−
During the drive keep full attention, to avoid any dangerous situation or collisions.
−
Do not overload the stroller. Overloading of a chassis, seat, bag or basket causes reduction
−
of stability of the stroller.
Make the full attention, when manipulate with the stroller, not to injure the child or your-
−
self.
If it is possible, always use drive-up ramps or lift to overcome any access restrictions.
−
Always lift the stroller in two persons.
−
Never transport the stroller when you and/or assistance are not sure if you can transport the
−
stroller with the child safely.
When you drive the stroller on the road, follow the road traffic regulations.
−
Do not use the stroller for any other purposes then it is designed for.
−
The stroller is designed to carry only one child.
−
Do not use any other than original PATRON accessories designed for this product.
−
When the stroller is folded and unfolded, the user guide must be followed carefully, to
−
avoid any damage on the construction what could affect the product stability.
In case of apparent defect, which limits product's safe using (e.g. damage of chassis, part
−
falls away or other optically visible defects, cracks etc.) it is necessary to stop using the
product immediately and contact your local official distributor or service centre.
Company PATRON does not bear any responsibility for the damages caused by using oth-
−
er than original PATRON accessories supplied by this company.
Company PATRON does not bear any responsibility for the damages and accidents caused
−
by inappropriate use of this product.
Opening the buggy:
stand buggy on wheels, unlock storage clip, grasp one handle and push down on the opposite seat tube. Press down firmly on seat tubes to ensure the
buggy is completely opened. Use foot to lock the rear brace into a straight position. Wrap the armrest padding around the armrests. Mount the footrest on
the buggy. (Lock the seat brace - size - 38)
Footrest:
install - put on the floor almost decomposed braked stroller and release both safety levers. Take the footrest, press spring button placed at the rear top of
the tube and pull both tubes into the both footrest attachments until they are locked in the lowest position by the rear spring button.
height adjustment - release both safety levers, pull both spring buttons of the footrest and adjust it into desired position. Tighten both safety levers to
secure the footrest in position.
uninstall - put on the floor almost decomposed braked stroller. Place the footrest into its lowest position, press the rear spring buttons and pull out the
footrests both side tubes at the same time.
Seat depth adjustment:
the seat should support the tights on their whole length. To change the seat depth undo the velcro panel connecting the seat and backrest and partially fold
the buggy to relieve fabric tension. Grasp end of seat tube, press seat spring button and move seat tube until spring button relocates into the desired hole.
Repeat for other side of seat. Fully open the buggy and fasten the velcro panel connecting the seat and backrest.
Backrest and handles height adjustment:
undo the velcro straps of the backrest extension and partially fold the buggy to relieve fabric tension. Grasp the handle, release handle safety lever, pull out
the handle quick release, move the handle until it relocates into desired position. Release the handle quick release by moving the handle. Tighten the
handle safety lever. Repeat for other handle and fully open the buggy. Fasten all velcro straps of the backrest extension.
Brakes:
lock - pull the brake lever down to lock the wheel
unlock - pull the brake lever up to unlock the wheel
Five-point belt:
release all plastic quick fasteners (fork type), place the child into the buggy and adjust of desired lengths the belt. Choose the hole in backrest to adjust the
proper position of the shoulders straps. The hole should be level with or higher than the top of the shoulders. The shoulders straps must be mounted on
backrest and backrest extension at once when possible.
Getting into the Buggy:
ensure the parking brakes are on, to make access easier, the footrest can be taken off; if possible, place the back of the buggy against a wall or immovable
USER GUIDE
5
Werbung
