Additional Regulatory Information; Fcc Compliance Statement; Zusätzliche Information - Bellman & Symfon BE1380 Bedienungsanleitung

Additional regulatory information

a) This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the bot-
tom of this equipment is a label that contains, among
other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
b) An applicable certification jacks Universal Service Order
Codes (USOC) for the equipment is provided (i.e., RJ11C)
in the packaging with each piece of approved terminal
equipment.
c) A plug and jack used to connect this equipment to the
premises wiring and telephone network must comply
with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed
to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
d) The REN is used to determine the number of devices that
may be connected to a telephone line. Excessive RENs on
a telephone line may result in the devices not ringing in
response to an incoming call. In most but not all areas, the
sum of RENs should not exceed five (5.0). To be certain of
the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone
company. [For products approved after July 23, 2001, the
REN for this product is part of the product identifier that
has the format US:AAAEQ##TXXXX. The digits represent-
ed by ## are the REN without a decimal point (e.g., 03 is
a REN of 0.3). For earlier products, the REN is separately
shown on the label.]
e) If this alarm clock equipment causes harm to the tele-
phone network, the telephone company will notify you
in advance that temporary discontinuance of service
may be required. But if advance notice isn't practical, the
telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
41
f ) The telephone company may make changes in its facili-
ties, equipment, operations or procedures that could af-
fect the operation of the equipment. If this happens the
telephone company will provide advance notice in order
for you to make necessary modifications to maintain unin-
terrupted service.
g) Should you experience trouble with this equipment,
please contact your retailer for information about war-
ranty and service. If the equipment is causing harm to the
telephone network, the telephone company may request
that you disconnect the equipment until the problem is
resolved.
h) Please follow instructions for repairing if any (e.g. battery
replacement section); otherwise do not alternate or repair
any parts of device except specified.
i) Connection to party line service is subject to state tariffs.
Contact the state public utility commission, public service
commission or corporation commission for information.
j) NOTICE: If your home has specially wired alarm equip-
ment connected to the telephone line, ensure the in-
stallation of this alarm clock does not disable your alarm
equipment. If you have questions about what will dis-
able alarm equipment, consult your telephone company
or a qualified installer.
NOTICE: According to telephone company reports, AC elec-
trical surges, typically resulting from lightning strikes, are
very destructive to telephone equipment connected to AC
power sources. To minimize damage from these types of
surges, a surge arrestor is recommended.
Applicable for Coin or Pay Phone Only
To comply with state tariffs, the telephone company must be
given notification prior to connection for customer-owned
coin or credit card phone. In some states, the state public
utility commission, public service commission or corporation
commission must give prior approval of connection.

FCC compliance statement

For ACTA:
REN: 0.1B
US: 1PNRG01BBERXTE1
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and re-
ceiver.
• Connect the equipment into an outlet on acircuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
For a complete Declaration of Conformity please contact:
info@bellman.com or call +46 31 68 28 20
Statement for Industry Canada
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Develop-
ment Canada's licence-exempt RSS(s). Operation is subject to
the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interfe-
rence that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d'Innovation, Sciences
et Développement économique Canada applicables aux
appareils radio exempts de licence. L' exploitation est autori-
sée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d' en compro-
mettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
IC: 6693A-BERXTE1 for Terminal Equipment
Zusätzliche Information
Zweckbestimmung des Produktes: Uhr mit Wecker Funktion inkl.
Vibrationskissen. Zulässige Betriebsbedingungen: Das Produkt
darf nur Innen verwendet werden. Reinigungshinweise: Nur
mit trockenem oder leicht feuchtem Tuch abwischen. War-
tungshinweise: Akkus können durch autorisiertes Fachpersonal
ausgetauscht werden. Bei Defekt des Blitzlichtes muss das
Gerät eingeschickt werden. Technische Daten: Betrieb mit 7.5V
Netzteil inkl. 4 x AAA NiMH-Akku (BE1350 Akkus optional) als
Überbrückung bei Stromausfall. Eingänge: Externer Trigger und
Telefon (Nicht BE1350). Ausgänge: Vibrationskissen. Hinweise
zum Wiedereinsatz: Das Produkt ist nicht für den Wiedereinsatz
für eine andere Person vorgesehen.
BE1580: HMV 16.99.09.3021 BE1350: HMV 16.99.09.3023
BE1370: HMV 16.99.09.3022
42