Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Electrical connections SINEAX C 402-1 in housing S17
Potentiometer
for trip point GW 2
Test sockets to GW 2
Potentiometer
for trip point GW 1
Test sockets to GW 1
1
6
–
I+
E
E = Measuring input
A1 = Output contacts for monitoring the trip point GW 1
9. Exchanging frontplate
ON
(
Fig. 4. Left: Removing the transparent cover
Right: Inserting the transparent cover.
Apply gentle pressure to the transparent cover as shown in
the left side of Fig. 4 until pops out on the opposite side.
The label in the cover can be replaced and used for notes.
22
All manuals and user guides at all-guides.com
Front
E
1
6
11
Camille Bauer AG
CH-5610 Wohlen
Switzerland
2
+
–
1
–
+
2
1
ON
3
8
13
4
9
14
5 10
View
without transparent
cover
GW 1
11
4
9
14
U+
A1
Energized:
4 – 9
Deenergized:
4 – 14
ON
(
1
6
11
SINEAX
Space e.g.
C 402
for MSK designation
2
Yellow LED
2
ON
for trip point GW2
1
Yellow LED
1
for trip point GW1
3
8
13
ON
Green LED for
4
9
14
device standing by
5 10
View
with transparent
cover
GW 2
3
8
13
A2
Energized:
3 – 8
Deenergized:
3 – 13
A2 = Output contacts for monitoring the trip point GW 2
H = Power supply
After replacing the label in the transparent cover, the trans-
parent cover can be snapped into the front of the device
again. This is done by inserting it behind the edge at the
bottom and pressing it gently down and to the rear with the
finger until it snaps into place (right side of Fig. 4).
10. Withdrawing and inserting the device
Fig. 5
5
10
–
+
H
(9)
(2)
ON
(
(
Werbung
Kapitel
Inhaltsverzeichnis
