Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Slide the quick release on the compressed air
2.
immediately stop using the device and get it
repaired by a professional.
3. Make sure that the air pressure regulator is
working and check it twice a day.
CAUTION: Never use the device without a
working retainer!
Before working with the device, it must be
tested using the following checklist. If there are
1. Disconnect the air hose from the unit and
remove all nails and staples.
•
• The retainer and the trigger should be free-
moving and easy to operate.
2. Set the air pressure to 70 PSI. Connect the air
hose to the device.
• There should be no leakage from the device!
3.
retainer against the wooden surface.
•
4. Break contact with the retainer and the
wooden surface. Point the device downwards,
seconds.
19
www. DeubaX X L. de
•
5. a.Press the retainer against the wood without
pulling the trigger. Then, pull the trigger.
•
distance the wood from the retainer.
•
drive plate stays down).
•
moves back to the top).
6. If the device is working properly, you can
now load staples into it. Fire staples into the
workpiece as normal.
•
Loading staples
NOTE: When loading the nails, be sure that the
smoothly in the magazine. Improper loading can
and damage to the unit.
1. Connect the air supply.
2. Press the magazine lock and open the
magazine as shown in the picture.
3.
appropriate nail size. Use suitable nails and
rail
4. Press the nail strip towards the front.
5. Close the magazine. The magazine lock should
Werbung
