Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AUDITOR
™
U s e r m a n u a l
28
Choosing the location
Before you begin installation, carefully choose where you would
like to fit the speaker drivers. The location of each speaker driver
will have an impact on the final acoustic rendering.
• Place the tweeters in one of the three locations shown in Fig. 1
(ASE 130 | ASE 165 | ASE 165 S).
Note: the closer the tweeter is to the listener's ears, the higher
the treble level. Adjusting the treble level on the source can
compensate for these variations.
• Place the woofers in one of the three locations shown in Fig. 2.
Fitting the woofers
Once you have chosen the speaker driver location, attach it directly
to the car door, or to a spacer using the screws provided. If the
speaker driver is visible, fit the grille provided as shown in Fig. 3 to
prevent any impact that could damage the woofer.
Fitting the tweeters
Once you have chosen the location, you can fit the tweeter in one
of two ways
• If you choose to fit the tweeter to the surface, in a location that
you have created, use Fig. 4 (Flush mount).
• If you install the tweeter in an existing location, you can remove
the front and back to reduce its size and position it more easily
(Fig. 5).
Connecting the product
Coaxial kits (Fig. 6).
Component kits (Fig. 7).
Werbung
