Unpacking Instruction; Power Supply; Getting Started - Plugger Studio MS4-BT Bedienungsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
DESCRIPTION
1. Volume control knob
2. Headphone output (Jack 3.5mm)
3. Bluetooth indicator led
4. Line input (RCA)
5. Line Out
6. Terminal block output
7. On / off button
8. Power cable
9. Terminal block input

Getting started:

Arrange your speakers so as to have optimal listening.
The MS4-BT consists of 2 loudspeakers. One active with all functions and settings and one passive.
The active speaker should be positioned on your right and the passive on your left.
Connect the 2 speakers with the speaker cable provided. To do this, connect the output terminals (red and black) of the active
speaker to the input terminal (red and black) of the passive speaker.
Connect the power cable to a 220-240VAC socket and switch on with the button (7)
Headphone socket (2)
Plug the headphones into the headphone jack to listen to music and adjust the volume using the volume button (1). The headset is
not included with the device.
Note: When using headphones, the speaker sound will be muted
5