Operation; Assembly Instruction - WARRIOR WEP8121LB Betriebsanleitung

KNOW yOUR BLOWER
KNOW yOUR BLOWER
Speed Slection
Button
LED Lamp
Blower Tube
Know your blower (see Figure 1)
The safe use of this product requires an understanding
of the information on the product and in this operator's
manual as well as a knowledge of the project you
are attempting. Before use of this product familiarize
yourself with all operating features and safety rules.
Trigger
Starts/stops the flow of air through the blower
Speed slection button
Increases or reduces the air velocity of the blower from
130-480CFM
Battery release button
Releases the battery pack from the blower
Blower tube
The blower tube can be easily installed on the blower
without any additional tools.
LED lamp
It can be used to illuminate under-lit or corner area
LED Indicator Light
Turbo Button
Battery Release Button
Trigger
Fig. 1

ASSEMBLy INSTRUCTION

WARNING
If any parts are damaged or missing, do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this
blower. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury
otherwise you will void any warranty offered.
Unpacking
Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
8
WARNING
Do not use this product if any parts on the packing list are
already assembled to your product when you unpack it. Parts on
this list are not assembled to the product by the manufacturer
and require customer installation. Use of a product that may
have been improperly assembled could result in serious personal
injury.
– Inspect the tool carefully to make sure no breakage
or damage occurred during shipping.
– Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
tool
– If any parts are damaged or missing, please return
the product to the place of purchase..
ASSEMBLING THE BLOWER TUBE
WARNING
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the tool when assembling parts.
1. Align either of the grooves the tube with the tabs
on blower housing. Push the tube onto the blower
housing until the tab engages the grooves (Fig. 2)
2. Pull out the tube from the tool lock position (Fig. 3)
Lock
Tube
Groove Fig. 2
ASSEMBLy INSTRUCTION
Lock Position

OPERATION

WARNING
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction or
distraction of a second is sufficient to inflict serious
injury on yourself or others.
WARNING
Always wear eye protection with side shields
marked to comply with ANSI 287.1, along with
hearing protection.
Failure to do so could result in objects being thrown
into your eyes and other possible serious injuries
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
Before each use, inspect the entire product for
damaged, missing, or loose parts, such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners
and caps and do not operate this product until all
missing or damaged parts are replaced.
WARNING
Always wear ear protection marked to comply with
ANSI 287.1, Failure to do so could result in hearing
loss and other possible serious injuries.
9
EN
Fig. 3