Product Specifications; General Safety Rules - WARRIOR WEP8121LB Betriebsanleitung

PRODUCT SPECIFICATIONS

PRODUCT SPECIFICATIONS
Cordless Leaf Blower
Type
Motor
Air Volume
Air Speed (Max)
Weight (Without Battery)
Weight (With 2.5AH Battery))
Battery Pack
Charger
Cordless battery-operated
60V
550CFM
120MPH
5lbs
8lbs
BP8302
C8360/C8362
2

GENERAL SAFETy RULES

WARNING
Read and understand all instructions before
using this product. Failure to read and follow all
instructions listed below may result in electric
shock, fire, and/or serious personal injury.
– Do not operate power tools in explosive
atmospheres, such as in the presence of flammable
liquids, gases, or dust. Power tools create sparks
which may ignite the dust or fumes.
– Do not allow children or untrained individuals to use
this unit.
–
Don't expose power tools to damp or wet conditions
including rain or snow. Water entering a power tool
will increase the risk of electric shock or death.
–
Do not handle plug or tool with wet hands always
wear gloves.
– Never allow children under 16 years old to operate
this equipment. Never allow adults to operate the
equipment without proper instruction.
– Always wear safety glasses with side shields
and ear protection that comply with ANSI Z87.1.
Everyday glasses are NOT classed as safety glasses
and MUST never be used. Following this rule will
reduce the risk of eye injury. Use face mask if area
or operation is dusty.
– Wear eye protection when operating this product.
Secure long hair above shoulder level to prevent
entanglement in moving parts.
– Use extra care when cleaning on stairs.
– Do not expose to any damp or wet conditions,
always store indoors.
–
Do not operate in poor lighting use only in day light.
– Keep all parts of your body away from any moving
part and never test air flow with bare hands.
– Keep hair, loose clothing, fingers and all body parts
away from openings, moving parts and air flow.
–
Wear heavy long pants, boots, and gloves. Avoid
loose garments and jewelry that could get caught in
moving parts of the machine or its motor.
GENERAL SAFETy RULES
–
Do not force tool. Use the correct tool for your
application. The correct tool will do the job better
and safer at the rate for which it is designed.
–
Do not operate the equipment while barefoot
or when wearing sandals or similar lightweight
footwear. Always wear protective footwear and PPE
that will protect your body parts and improve your
footing on slippery surfaces.
– Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance.
– Do not allow to be used as a toy or weapon. Close
attention is necessary when used by or near
children otherwise you will void any warranty
offered.
– Do not use tool if switch does not turn it on or off.
Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
– Keep all bystanders, children, and pets at least 50
ft. away.
– Do not operate this unit when you are tired, ill, or
under the influence of alcohol, drugs, or medication.
– Keep all parts of your body away from any air flow
and all hot surfaces of the unit
– Do not put any object into openings. Do not use with
any opening blocked; keep openings free of dust,
lint, hair, and anything that may reduce air flow.
– Check the work area before each use. Remove all
objects such as rocks, broken glass, nails, wire, or
stones as these can be thrown.
– Use only identical manufacturer's replacement parts
and accessories. Use of any other parts may create
a hazard or cause product damage.
– Do not use or charge battery and tool in damp or
wet conditions. Following this rule will reduce the
risk of electric shock.
– For household use only.
– Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Always disconnect or remove
battery and be aware of possible hazards when
not using your battery tool or when changing
accessories. Following this rule will reduce the risk
of electric shock, fire, or serious personal injury.
–
Remove or disconnect battery before servicing,
cleaning or removing material from this tool.
3
EN