Hard Head 791-212 Montageanleitung Seite 17

NOTE: The internal cord guide and brake unit can be fitted to the left or right of the window.
1. Drill a hole in the wall for the rubber lead-through and remove the dust. The hole through the wall
should angle down 3° from the inside to prevent rainwater getting into the wall.
2. Cut the rubber lead-through to the thickness of the wall and insert it in the hole in the wall.
3. Put the cord guide on the outside in its upper position and the cord guide on the inside in its lower
position.
4. Pull the cord through the cord guide on the outside, through the rubber lead-through, and through
the cord guide on the inside, the brake unit and catch.
5. Fit suitable plastic expander plugs and screw on the fasteners.
ENGLISH
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
A.
B.
17
Locking pin
Frame
Rubber lead-through,18 mm
Cord guide, outside
Awning fabric
Bar
Bar fastener, front edge
Catch
Brake unit
Cord
Cord guide, inside
Inside
Outside
1. Cord guide, inside
2. Brake unit
3. Catch
4. Rubber lead-through
5. Window