Hard Head 791-212 Montageanleitung Seite 16

Installation
1. First decide where to place the cord and brake unit. On delivery the equipment is prefitted for the
cord and brake unit to be placed to the right of the window. To move the cord and brake unit to the
left side, remove the screws holding the left and right plastic caps and remove the caps. Move the
cord shaft to the left side and rewind the cord on the wheel in the other direction. Replace the caps
and screws.
2. Mark out the mounting holes on the outer wall and drill the holes. Insert plastic expander plugs and
fit the fasteners.
3. Hook the product in the fasteners. It will click when it locks in place.
ENGLISH
Plastic expander plug, Ø 8 mm
Screw M5 x 40, stainless steel
16
10
10
A. Bar length + 15 mm.
B. Check that the hole in
the frame and the
hole for the locking
pin are vertically
aligned.