Inhaltsverzeichnis
Werbung
LINE OUT CONNECTIONS
1
XLR m
3
12
11
10
2
RACK INSTALLATION (LDIMARK rack installation kit available as an option)
The optionally available LDIMARK rank installation kit contains rack-mount brackets and connecting pieces for fixed installation of PRE ST 1, IMA 30
and IMA 60 mixing amplifiers (single or two side by side) in a 19" rack. The installation kit includes the following components:
2 rack-mount brackets with short sides
D
bottom
, 4 M4 flathead screws for the rack-mount brackets, 8 M3 countersunk screws for the plates
A
A
The installation of a single amplifier requires one rack-mount bracket with short sides
the bracket with the short sides to either the left or right side of the amplifier and the bracket with the long side to the opposite side. Use the M4
flathead screws for this.
A
If you want to install two amplifiers side by side in a 19" rack, you will need the two small plates to connect the amplifiers together at the back
, the two rectangular plates for connection at the bottom
screws on the back and secure the plates with these screws
intended positions on the amplifiers, as shown below. Screw the rack-mount brackets with the short sides
M4 flathead screws.
A
9
8
7
A
, 1 rack-mount bracket with long side
B
D
and the two rack-mount brackets with short sides
C
. Screw the connecting plates
C
C
1
XLR m
3
6
5
2
B
, 2 small plates for the back
D
.
A
and the rack-mount bracket with long side
B
D
in with the supplied M3 countersunk screws to the
A
+
-/G
4
3
C
, 2 rectangular plates for the
C
D
B
. Screw
C
A
. Loosen the corresponding
to the sides of the device using the
A
2
1
11
Werbung
Inhaltsverzeichnis
