URBANGLIDE BIKE M2S Benutzerhandbuch Seite 10

Once the wheel is securely inserted into the fork, tighten the metal
rod using the locking lever on the fork. (13)
Once the assembly is finished, make sure that all parts are tight and
properly adjusted. Check that the brake system is correctly positioned
and that the brake pad is inserted.
Check that the handlebars are straight and tight.
Check that the saddle is aligned with the dial on the bike, and that it is
tight.
14
Now the top of the mudguard has to be fixed. The
buckle on the mudguard must be level with the front fork
of the bike. Unscrew the screw at the back of the front
light. Insert the buckle and put the screw back in its
original place (15). When you unscrew the screw behind
the front light, the front light will be unstable. When you
tighten the screw again, adjust the position of the front
light. To finalize the fixing of the front mudguard.
13
Once the wheel is securely fixed, the front
mudguard must be fitted. To do this,
insert the two metal rods attached to the
mudguard into the two black end caps
located on each side of the front wheel
(14). In order to insert the metal rods, the
screws on the black end cap, which holds
the grey rods, must be unscrewed.
Slightly unscrew the external screws and
then insert the rods of the mudguard.
Tighten the screws again to fix the
mudguard. Caution! You must adjust your
mudguard so that it does not rub on your
wheel. To do this, push in or out the metal
rods and adjust the position of the
mudguard.
15
10