Care And Maintenance; Battery Safety Instructions - Levenhuk LabZZ M101 Bedienungsanleitung

Notes:
1. The Levenhuk K50 experiment kit is supplied without an individual plastic case.
2. Batteries might be pre-installed in the battery compartment by the manufacturer.

Care and maintenance

Never, under any circumstances, look directly at the Sun, another bright source of light or at a laser
through this device, as this may cause PERMANENT RETINAL DAMAGE and may lead to BLINDNESS.
Take necessary precautions when using the device with children or others who have not read or who do
not fully understand these instructions.
every component and connection.
Do not try to disassemble the device on your own for any reason. For repairs and cleaning of any kind,
please contact your local specialized service center.
Protect the device from sudden impact and excessive mechanical force. Do not apply excessive pressure
when adjusting focus. Do not overtighten the locking screws.
to clean the optics.
Do not use the device for lengthy periods of time, or leave it unattended in direct sunlight. Keep the device
away from water and high humidity.
to protect the device from dust and stains.
If you are not using your microscope for extended periods of time, store the objective lenses and eyepieces
separately from the microscope.
Store the device in a dry, cool place away from hazardous acids and other chemicals, away from heaters,
Always unplug the microscope from a power source before opening the base or changing the illumination
lamp. Regardless of the lamp type (halogen or incandescent), give it some time to cool down before trying
to change it, and always change it to a lamp of the same type.
the microscope, burn out the lamp, or even cause a short circuit.
Seek medical advice immediately if a small part or a battery is swallowed.

Battery safety instructions

Always purchase the correct size and grade of battery most suitable for the intended use.
Always replace the whole set of batteries at one time; taking care not to mix old and new ones, or batteries
Clean the battery contacts and also those of the device prior to battery installation.
Make sure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment that is not to be used for an extended period of time.
Remove used batteries promptly.
Never short-circuit batteries as this may lead to high temperatures, leakage, or explosion.
Never heat batteries in order to revive them.
Utilize used batteries as prescribed by your country laws.
4